电子制作天地网站欢迎您的光临,欢迎提出宝贵意见或建议。本站信息产业部备案: 粤ICP备05114582号
电流反馈型A类功率放大器制作
class a power amplifier

时间:2008-3-6 21:46:30 来源:本站收集 作者:Cooltune 编辑: 【关闭


电流反馈型A类功率放大器制作,class a power amplifier

关键字:电流反馈型A类功率放大器制作

本篇文章源自http://www.cooltune.ch/Projects/Megalith01.htm

Introduction

My first set of electronics started in 1979 as an experiment based on a design published in the French magazine "l'Audiophile No. 10" by Jean Hiraga.



Modified Version of Hiraga's Class A Amplifier

Although a Class A triode push-pull or single ended tube amplifier might have been the better choice in those days (and possibly still today), I was highly attracted by the new developed Hitachi FET-Devices. As owner of the high efficient Onken-Mahul System, most of the time 1 watt with peaks to 8 watt were absolutely sufficient. So, I decided to simplify the modified version of Hiraga?s Class A Amplifier once more (reduction of open-loop gain and use of less discrete components) and settled for a class A operation of 8 watt.



FET Amplifier No. 1



Power Supply for FET Amplifier No. 1



This FET Power Amplifier No. 1 was produced in 1980 for several music enthusiast and colleagues. Today, after 23 years some of these power amplifiers are still in use and according to the owners they perform much better than many high rated commercial amplifiers.

Design Considerations

Encouraged by the friendly, direct and immediate sound of the FET Amplifier No.1 and repeated requests from some of the owners to design an improved successor, I finally decided in 2000 to start the task. But, where should the existing design be improved?

Suspecting that the ear compensates for amplifier distortion, when it is simple in nature over the entire power range, but does not like distortion of high harmonic order that is constantly changing with the music, it became immediately clear I should primarily improve the power supply. The only way to accomplish this is the use of regulated power supplies or accumulators. Since I wanted an excellent and simple solution, I chose the accumulators.

Other areas of improvements are a further reduction in components and the use of more linear discrete semiconductors.



Megalith - FET Power Amplifier No. 2

Along with the effort of improving the existing FET Power Amplifier No.1, I considered other topologies which may have a similar performance.

附件:相关电路图、PCB及元件清单.rar


◆相关文章◆
◆ 编辑推荐 ◆
用户:
更多评论
您要为您所发的言论的后果负责,故请各位遵纪守法并注意语言文明。60个字以内
留言:
验证码:

免责声明:
●本站所有内容均来自网络,以学习为目的,如果侵犯了您的利益,请来信告知,立即删除,站长邮件为"diy+dzdiy.com",请将"+"变更为"@"
●电子制作存在风险,请注意人身安全,如果您在根据本站电路进行制作过程中发生伤害,本站不负任何责任。

版权所有:www.dzdiy.com ? 2001-2019 本站信息产业部备案: 粤ICP备05114582号